The type of stainless steel pipe fittings is a problem that people are more concerned about, so what kinds of stainless steel pipe fittings can be divided into?

1 good stainless steel elbow appearance is beautiful, texture performance is strong, you can use your eyes to check whether it is smooth, not rough; 2. There are related product instructions, you can check its structure, material and other aspects; 3. People who buy stainless steel elbow can check whether the material is stainless steel, the chemical composition it contains will keep the surface of the elbow for a long time will not rust, will not be corrosion; 4. Choose enterprises with good service and sales of stainless steel elbow, and solve problems in time. 5. The enterprise is fully qualified and has the corresponding certificate. The stainless steel elbow made by such an enterprise is relatively good.

1. During installation, the stainless steel elbow can be directly installed on the pipeline according to the connection mode, and installed according to the position of use. In general, it can be installed in any position of the pipeline, but it needs to be easy to operate the inspection, pay attention to the flow direction of the stainless steel elbow medium should be upward below the vertical valve disc, and the stainless steel elbow can only be installed horizontally. 2. Stainless steel elbow with hand wheel, do not use lever or other tools, so as not to damage the valve. 3. Stainless steel elbow ball valve, globe valve, gate valve when used, only fully open or fully closed, not allowed to adjust the flow, so as to avoid erosion of sealing surface, accelerate wear. 4. Long-term storage of stainless steel elbow, should be regularly checked, often exposed processing surface must be kept clean, clean up dirt, neatly stored in a dry indoor place, pile or open storage is strictly prohibited. Always keep the stainless steel elbow dry and ventilated, keep the retainer clean and tidy, according to the accurate storage method. 5 stainless steel elbow valve packing gland bolts should be tightened evenly, should not be pressed into a crooked state, so as not to interfere with the stem movement or cause leakage.